Differences

This shows you the differences between two versions of the page.

--- pub:projects:3d_printers_and_3d_printing:flashforge_creator_3_pro [2026/04/03 00:39] – admin
+++ pub:projects:3d_printers_and_3d_printing:flashforge_creator_3_pro [2026/04/03 00:40] (current) – admin
@@ Line 5: / Line 5: @@
 Did you ever try to turn on the left or right cooling fan at the Flashprint((The Slicer provided by Flashforge, currently at Version 5.8.7, [[https://www.flashforge.com/pages/software-flashprint]])) control panel and observed that only the right cooling fan actually spins? I stumbled upon this, contacted Flashforge customer support, but after many fruitless discussions, it was also clear that Flashforge wasn't interested to fix anything at all.
-When testing with a gcode file((The printer uses a .gx format, which is similar to gcode but with an additional header at the top. Further info can be found here: [[https://github.com/slic3r/Slic3r/issues/4869 and https://bkienzle.com/posts/converting-flashforge-file-format/]].)).
+When testing with a gcode file((The printer uses a .gx format, which is similar to gcode but with an additional header at the top. Further info can be found here: [[https://github.com/slic3r/Slic3r/issues/4869]] and [[https://bkienzle.com/posts/converting-flashforge-file-format/]].)).
 This long article is about getting the left cooling fan to work, starting reverse engineering with Ghidra and patching the firmware and much more.

wiki.auditeon.com